Product ID:LORD ACCELERATOR 5
MSDS Date:08/28/1998
FSC:8040
NIIN:01-174-4684
Status Code:A
Kit Part:Y
MSDS Number: CJHQX

Emergency Phone: 814-763-2345

Info Phone: 814-868-3611

Cage: 30676

Telephone: 814-868-3611

Cage: 30676

BENZOYL PEROXIDE

CAS: 94-36-0

RTECS: DM8575000

OSHA PEL 5 MG/M3

ACGIH TLV: 5 MG/M3

DIISOBUTYL PHTHALATE

CAS: 84-69-5

RTECS: TI1225000

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EMERGENCY OVERVIEW: MAY CAUSE SKIN AND
EYE IRRITATION. MAY CAUSE RESPIRATORY TRACT IRRITATION. ACUTE: EYE:
MAY CAUSE IRRITATION. SKIN: MAY CAUSE IRRITATION. MAY CAUSE
DERMATITIS. INHALATION: MAY CAUS E RESPIRATORY TRACT IRRITATION.
INGESTION: HARMFUL IF SWALLOWED. INGESTION IS NOT AN EXPECTED ROUTE
OF ENTRY IN INDUSTRIAL OR COMMERCIAL USES. CHRONIC: CHRONIC SKIN
CONTACT MAY CAUSE DERMATITIS.
Effects of Overexposure:SEE HEALTH HAZARDS.

First Aid:EYE: FLUSH IMMED W/LG AMT OF WATER FOR AT LIST 15 MINS
HOLDING EYELIDS OPEN WHILE FLUSHING. GET PROMPT MED ATTN. SKIN:
FLUSH CONTAMD SKIN W/LG AMTS OF WATER WHILE REMOVING CONTAMD CLTHG.
WASH AFFECTED SKIN AREAS W/SOAP & WATER. GET MED ATTNIF SYMPS
OCCUR. INHAL: MOVE PERSON TO FRESH AIR. RESTORE & SUPPORT CONTINUED
BRTHG. IF BRTHG IS DFCLT, GIVE OXYG. GET IMMED MED ATTN. INGEST: DO
NOT INDUCE VOM IT. GIVE VICTIM 1-2 GLASSES OF WATER/MILK. CALL
PHYS/POIS CTL CTR IMMED FOR FURTHER INSTRUCTIONS. NEVER GIVE
ANYTHING BY MOUTH TO UNCON PERSON.

Flash Point Method:SCC
Flash Point:>93.3C, 200.F
Extinguishing Media:CO*2, DRY CHEMICAL, FOAM, WATER FOG.
Fire Fighting Procedures:NIOSH APPRVD SCBA & FULL PROT EQUIP . IF
WATER IS USED, FOG NOZZLES ARE PREFERABLE. DURING FIRE, IRRITATING
AND OR TOXIC GASES AND PARTICULATE MAY BE GENERATED BY THERMAL
DECOMPOSITION OR COMBU STION.
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS MAY RUPTURE WHEN
EXPOSED TO EXTREME HEAT. USE WATER SPRAY TO KEEP FIRE EXPOSED
CONTAINERS COOL. OSHA FLAMMABILITY CLASSIFICATION: COMBUSTIBLE
LIQUID - CLASS IIIB.

Spill Release Procedures:AVOID BREATHING VAPORS. USE NIOSH APPROVED
SCBA. NOTIFY APPROPRIATE AUTHORITIES IF NECESSARY. CONTAIN & REMOVE
WITH INERT ABSORBENT MATERIAL. AVOID CONTACT. KEEP NON-ESSENTIAL
PERSSONNEL AWAY FROM SPI LL AREA. BEFORE ATTEMPTING CLEANUP, REFER
TO HAZARD CAUTION INFO IN OTHER SECTIONS OF MSDS.

Handling and Storage Precautions:STORE ONLY IN WELL-VENTILATED AREAS.
KEEP CONTAINER CLOSED WHEN NOT IN USE. KEEP CLOSURE TIGHT AND
CONTAINER UPRIGHT TO PREVENT LEAKAGE. AVOID SKIN AND EYE CONTACT.
AVOID BREATHING OF VAPOR OR SPRAY MISTS.
Other Precautions:DO NOT HANDLE UNTIL ALL SAFETY PRECAUTIONS HAVE BEEN
READ AND UNDERSTOOD. EMPTY CONTAINERS SHOULD NOT BE RE-USED. USE
WITH ADEQUATE VENTILATION.

Respiratory Protection:USE NIOSH APPROVED AIR-PURIFYING ORGANIC VAPOR
RESPIRATOR IF OCCUPATIONAL LIMITS ARE EXCEEDED. FOR EMERGENCY
SITUATIONS, CONFINED SPACE USE, OR OTHER CONDITIONS WHERE EXPOSURE
LIMITS MAY BE GREATLY EX CEEDED, USE NIOSH APPROVED
AIR-SUPPLIEDRESPIRATOR. OBSERVE OSHA REGULATIONS (29CFR 1910.134)
FOR RESPIRATOR USE.
Ventilation:SUFFICIENT VENTILATION IN PATTERN & VOLUME SHOULD BE
PROVIDED IN ORDER TO MAINTAIN AIR CONTAMINANT LEVELS BELOW REC
EXPOSURE LIMITS.
Protective Gloves:USE NEOPRENE, NITRILE/RUBBER GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:EYEWASH AND DELUGE SHOWER MEETING ANSI
DESIGN CRITERIA . REMOVE & WASH CONTAMINATED CLOTHING BEFORE
REUSE.
Work Hygienic Practices:WASH HANDS BEFORE EATING, SMKNG/USING TOILET
FACILITY. DO NOT SMOKE IN ANY CHEM HNDLG/STOR AREA. FOOD/BEVERAGES
SHOULD NOT BE CONSUMED ANYWHERE THIS PROD IS HANDLED/STORED. WASH
THOROUGHLY AFTER HNDLNG.
Supplemental Safety and Health
PHYSICAL PROPERTIES: DENSITY (LBS/GAL): 9.6. VOLATILE ORGANIC COMPOUNDS
(CALCULATED): 0.00 LBS/GAL, 0 GRAMS/1LTR.

Boiling Pt:=100.C, 212.F
Vapor Density:HVR/AIR
Spec Gravity:1.15
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:INSOLUBLE
Appearance and Odor:WHITE PASTE, SWEET ODOR.
Percent Volatiles by Volume:5.7

Stability Indicator/Materials to Avoid:YES
STRONG ACIDS, BASES, AND STRONG OXIDIZERS.
Stability Condition to Avoid:HIGH TEMPERATURES.
Hazardous Decomposition Products:CARBON MONOXIDE, CARBON DIOXIDE.
Conditions to Avoid Polymerization:WILL NOT OCCUR UNDER NORMAL
CONDITIONS.

Waste Disposal Methods:DISPOSAL SHOULD BE DONE IN ACCORDANCE WITH
FEDERAL (40 CFR PART 261), STATE & LOCAL ENVIRONMENTAL CONTROL
REGULATIONS. IF WASTE IS DETERMINED TO BE HAZARDOUS, USE LINCENSED
HAZARDOUS WASTE TRANSPORTER AND DISPOSAL FACILITY.

Toxicological Information:PRODUCT LD50 (ORAL) AND (DERMAL): NO DATA.
PRODUCT LC50: NO DATA.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.

Ecological:NO INFORMATION.

Transport Information:DOT PROPER SHIPPING NAME: ORGANIC PEROXIDE TYPE
E, SOLID. DOT HAZARD CLASS: 5.2. DOT UN/NA NUMBER: UN3108.
EMERGENCY RESPONSE GUIDE NUMBER: 145. PACKING GROUP: II.

SARA Title III Information:THIS PRODUCT CONTAINS THE FOLLOWING
SUBSTANCES SUBJECT TO THE REPORTING REQUIREMENTS OF SECTION 313 OF
TITLE III OF THE SUPERFUND AMENDMENTS AND REAUTHORIZATION ACT OF
1986 AND 40 CFR PART 372: CHEMIC AL NAME: BENZOYL PEROXIDE, CAS
NUMBER: 94-36-0, WT% IS LESS THAN: 45%.
Federal Regulatory Information:OSHA: HAZARDOUS BY DEFINITION OF HAZARD
COMMUNICATION STANDARD (29 CFR 0910.1200). INVENTORY STATUS: THE
CHEMICAL SUBSTANCES IN THIS PRODUCT ARE ON THE TSCA SECTION 8
INVENTORY. INTERNATIONAL REGULATI ONS: AS FOLLOWS: CANADIAN WHMIS:
THIS MSDS HAS BEEN PREPARED IN COMPLIANCE WITH CONTROLLED PRODUCT
REGULATIONS EXCEPT FOR USE OF THE 16 HEADINGS. CANADIAN WHMIS
CLASS: D2A, D2B.